1985 Ford Bronco
Owner: David Lithgow 
From: Port St. Lucie, FL, U.S.A.        (Other registries in FL)
Year, Make, & Model: 1985 Ford Bronco        (Other Ford Broncos)
Avatar:
Clubs: SuperFord.org        (Other vehicles in this club)
Nickname: Converted
Mileage:
Engine: * 351W +.060, -.010 deck
* Polished Balanced Cast Crank
* Ported/polished/matched/shaved heads
* 9.5:1CR
* Melling Oil Pump
* Edelbrock Performer Intake Manifold
* Edelbrock Performer #1407 750cfm Carb
* Compcams 35-238-3 extreme energy 4x4 cam
* Trick Flow Valve Springs/Retainers/Keepers/Shims
* K+N 2"x14" in stock air cleaner W/ double cold air intakes
* Summit shorty truck headers
* Flowmaster Y-pipe and 40 series muffler
* MSD blaster coil
* Stock Duraspark II
* Ford Motorsports 9MM plug wires
* Ford Motorsports Cap & Rotor
* Bosch P+4's
Drivetrain: * C6 Transmission
* NP 208 Transfer Case
* 9" open rear with 3.50's
* D44 open TTB Front
* SuperWinch Manual Locking Hubs
Notes: * Maximum Cooling Radiator
* R134a Converted A/C (Details in Pics section)
* 33x12.50x15
* 3" body lift
* Poineer DEH-445 High Power Super Tuner / CD
* Audiovox 400W Amp
* Hi-Lift 48" Cast Jack

------- Wish List -------
- Jacobs Off-Road ignition system
- Detroit or ARB locker out back
- Winch in Front
- 2" suspension Lift, New coils and Camber Adjusters
in front and shackle inversion in back.
- Raise gas tank to top of cross member +/- 3"
- Raise Bumpers to stock location (vs. Body)
- Raise Class V Hitch to Frame top web.
- Paint Job and minor rust repair
- If I get a commuter vehicle 4.11 or 4.56 gears + 35" tires
Last Updated: 6/28/2002
Hits: 24994
Album
Folder Hits Comments Created Updated
folder '85 Bronco000006/29/036/29/03
    folder Tires / Wheels10087606/29/036/29/03
    folder Soft Top4007,70806/29/036/29/03
    folder Misc Bronco Pics10073106/29/036/29/03
    folder R134a A/C Conversion6004,76506/29/036/29/03
    folder Interior2002,28706/29/036/29/03
    folder Edelbrock Carb50012,66806/29/036/29/03
    folder Front bumper relocation project4003,83206/29/036/29/03
    folder Shop Equipment2001,84306/29/036/29/03
Newest Media Files
20_Gal_Harbor_Freight_parts_washer__a_couple_repai
840 hits | 42.5 KB | Posted: 6/29/03

20 Gal Harbor Freight parts washer (& a couple repair manuals)
12_Ton_Central_Machinery_Harbor_Freight_shop_press
1003 hits | 32.82 KB | Posted: 6/29/03

12 ton central machinery (Harbor Freight) shop press.
Front_Bumper_After_Lift-4.jpg
1049 hits | 28.62 KB | Posted: 6/29/03

Close up side view. Thank you Ford engineers for the convenient cup holder
Front_Bumper_After_Lift-3.jpg
964 hits | 31.65 KB | Posted: 6/29/03

Approach angle will get a little better
Front_Bumper_After_Lift-2.jpg
1026 hits | 30.25 KB | Posted: 6/29/03

Body lines should line up with bumper
Front_Bumper_After_Lift.jpg
793 hits | 27.24 KB | Posted: 6/29/03

Bumper sitting at stock height on frame but 3" low on body
SSCN0460.JPG
1372 hits | 52.29 KB | Posted: 6/29/03

Side view of the throttle and kickdown connections
SSCN0464.JPG
1927 hits | 51.89 KB | Posted: 6/29/03

This pic shows the Ford adapter (Edelbrock #1483)
SSCN0463.JPG
5788 hits | 46.16 KB | Posted: 6/29/03

The throttle cable bracket had to move about an inch towards the drivers side to line up with the Ford kickdown linkage adapter (P/N 1483)
Most Viewed Files
SSCN0463.JPG
5788 hits | 46.16 KB | Posted: 6/29/03

The throttle cable bracket had to move about an inch towards the drivers side to line up with the Ford kickdown linkage adapter (P/N 1483)
SSCN0055.JPG
3644 hits | 36.71 KB | Posted: 6/29/03

Fast Back Soft Top
SSCN0461.JPG
2124 hits | 49.56 KB | Posted: 6/29/03

I had to extend fuel line to right side and extend PCV to front of carb
SSCN0464.JPG
1927 hits | 51.89 KB | Posted: 6/29/03

This pic shows the Ford adapter (Edelbrock #1483)
SSCN0064.JPG
1760 hits | 48.71 KB | Posted: 6/29/03

Side View
Sunpro_Guages.jpg
1518 hits | 26.97 KB | Posted: 6/29/03

Sunpro Tach & Guages
SSCN0462.JPG
1458 hits | 51.32 KB | Posted: 6/29/03

Sittin' Pretty
SSCN0460.JPG
1372 hits | 52.29 KB | Posted: 6/29/03

Side view of the throttle and kickdown connections
HeadRoom.jpg
1247 hits | 20.78 KB | Posted: 6/29/03

Interior head room with soft top
Maintenance & Modification Logs
This user hasn't added any log entries, yet.
About SuperMotors | Contact Us | FAQ/Help | Legal
Copyright © 1998-2024 Web Design Solutions, Inc.
All rights reserved. Duplication & reproduction is strictly prohibited.
SuperMotors.net v5.0.2 ChangeLog