1986 Ford Bronco
| Owner: |
Kurt Hartsig |
| From: |
Seattle, WA, U.S.A. (Other registries in WA) |
| Year, Make, & Model: |
1986 Ford Bronco (Other Ford Broncos) |
| Clubs: |
SuperFord.org (Other vehicles in this club)
2 Big Broncos Northwest (Other vehicles in this club)
BigBroncos.com Registry (Other vehicles in this club)
|
| Nickname: |
WildHorses |
| Mileage: |
|
| Engine: |
Injected 5.8L
1996 351EFI MAF
OBD-II Computer diagnostics
Basic. Motorsport 9mm plug wires
Custom Y-pipe, HiFlow Cat, Flowmaster muffler
K&N Filter
Fuel system delivered via internal tank & external high pressure pumps
Fuel Pressure gauge, mounted on hood
Coolant Temperature gauge
Oil Pressure gauge |
| Drivetrain: |
E40D Transmission
B&M Shiftkit - Street Racing spring set (seriously hard shift)
Ford Motorsport stack plate tranny cooler
ATF Pan Temperature gauge
Transfer Case
BW-1356
Front Axle
Dana 60 High pinion, King pin design
4.56 gear ratio
ARB Air locker w/ ARB compressor
35 Spline axle shafts
Warn manual hubs
Rear Axle
Ford Dana 60
4.56 gear ratio
Detroit locker
Ron's CustomShop Diff Guard
30 Spline, full floater axle shafts
Ford ABS Exciter ring feeds ABS, PSOM to OBDII computer VSS
Suspension
4-5" Suspension Lift, 1" Body lift
Front - Chevy 1/2ton 4" leaf springs (Rancho RSP 40054S)
Custom shackles .5x2.5x6.5" pivot points)steel plate mounted at ~40deg inward angle
Rancho 5000 shocks (RSP #5012)
Front Shock Towers (Ford E5TZ*18183*A) welded in place
Rear - Superlift 4" leaf springs
Rancho 9000 Adjustable shocks
Custom drive shafts
Front is .120 DOM tubing to length of XXinchs
Rear is 1986 stock rear shaft shorten to length of XXinchs
|
| Notes: |
2-Big Broncos 4x4 Club, Northwest Chapter & Other Club Member Vehicles
Wide Range of Model Years
1978 Dana 60 axles both front and rear
1986 Body style
1987 Fuel System with external and internal pumps
1989 F350 Brake booster and master cylinder
1992 PSOM/Speedometer HUD
1996 5.8L EFI MassAir; E40D automatic transmission
Custom Tube Cage
Using DOM .120 thickness 50' of 2" tubing; 35' of 1.5" tubing
Cage has six legs with 3/16" plate footings
Provides me with frame for canvas soft-top
Few Add-Ons and Tweaks
Custom 2" and 1.5" DOM tubing cage
Custom canvas softtop over cage
ARB Front bull-bar winch bumper
WARN12000 Electric winch
Custom rear SabreForce bumper with tire carrier and lights
Custom "Andy Skaar" Rocker Guards
1" Custom body lift using polyurathane 65D bar stock
Dual batteries - Optima Red/Yellow
DC/AC Power Inverter
Bench Seat
Custom made HALF-DOORS
|
| Last Updated: |
5/28/2003 |
| Hits: |
40290 |
Click on an album section above to view its contents.
