DCP_0603.JPG 3661 hits | 47.42 KB | Posted: 8/7/03 Begin by removing the exterior snap rings which retain the u-joint caps
DCP_0604.JPG 3099 hits | 60.91 KB | Posted: 8/7/03 You must remove the lower joint first
DCP_0605.JPG 3328 hits | 62.73 KB | Posted: 8/7/03 On the left you see the centering ball and needles within. On the right you see the post that rides...
DCP_0606.JPG 2964 hits | 12.14 KB | Posted: 8/7/03 New centering ball, Napa part #612.... but that seal (on the lower left) does not work. Call a comp...
DCP_0607.JPG 2987 hits | 43.19 KB | Posted: 8/7/03 New rubber seal which surrounds the centering post. Try Spicer part # 412-2
DCP_0609.JPG 2789 hits | 54.44 KB | Posted: 8/7/03 This seal has a small lower metal lip. I used a large socket of the appropriate size to tap it into...
DCP_0610.JPG 3096 hits | 40.79 KB | Posted: 8/7/03 I installed the centering ball in a similar fashion, using a socket to drive it in
DCP_0611.JPG 3619 hits | 34.85 KB | Posted: 8/7/03 THIS IS THE HARDEST PART. You must drop the post and spring into the centering ball without disturb...
DCP_0613.JPG 2777 hits | 45.84 KB | Posted: 8/7/03 Be certain that your zerks (or nubs for zerks) are pointing away from each other or angularity will ...
DCP_0615.JPG 2635 hits | 27.13 KB | Posted: 8/7/03 Let the rear axle free-hang and check for binding by turning the d/s. If binding is detected you ca...
Double Cardan Rebuild
