Picture 102.jpg 610 hits | 58.84 KB | Posted: 5/24/04 my new battery holddown, much better then a bungee cord that barely held down the aux battery I got ...
Picture 103.jpg 547 hits | 68.89 KB | Posted: 5/24/04 those ghetto spacers are there because I didnt count on the threads not going far enough down the sh...
Picture 104.jpg 456 hits | 74.53 KB | Posted: 5/24/04 its 18" long with the hold down bolts 15" apart. One on an eye bolt threw the body the other in the ...
Picture 105.jpg 535 hits | 66.13 KB | Posted: 5/24/04 I may still stick another hold down bolt in the center. I had originally planned on using a peice of...
Picture 106.jpg 594 hits | 67.39 KB | Posted: 5/24/04 And finally for those of you who asked how my dash swap was going... here it is today... not much ha...
Picture 002.jpg 556 hits | 57.72 KB | Posted: 7/3/04 The spot I chose for my 3 1/2 tach. There is a hole in the sheetmetal here for the a pillar plastic...
Picture 008.jpg 660 hits | 66.07 KB | Posted: 7/3/04 I still have a lot of work to do on it, but the hard part is over with.
Picture 009.jpg 498 hits | 57.31 KB | Posted: 7/3/04 left support bracket, 5 holes long
Picture 010.jpg 657 hits | 64.88 KB | Posted: 7/3/04 gauges, lights that arent hooked up yet and I may have to get a new blue one since that one got betw...
Picture 011.jpg 583 hits | 52.12 KB | Posted: 7/3/04 another shot of the tach. where its gonna be mounted when the JB weld drys all the way.
Picture 002.jpg 572 hits | 98.58 KB | Posted: 12/2/04 sheet metal and some hole saws
Picture 147.jpg 542 hits | 39.02 KB | Posted: 12/2/04 Plug to heater fan resistor. Now just look at wiring diagram and connect the switch to the resistor...
Picture 150.jpg 493 hits | 42.4 KB | Posted: 12/2/04 cut out to remove both from engine bay.. turns out valve cover is in the way of heater core
2003-2004 dash, rear end etc.
