S3500431.JPG
725 hits | 74.43 KB | Posted: 3/20/04
The factory setup, the breather tube goes into the air box towards the rear. (You can see it just be...

S3500433.JPG
640 hits | 77.34 KB | Posted: 3/20/04
Air box and breather tube removed. I had to cut the hose off of the oil fill spout to get the tube ...

S3500421.JPG
654 hits | 37.28 KB | Posted: 3/20/04
I bought a K&N crank case vent filter (summit part #KNN-62-2470) and a 3’ piece of
-10AN braided s...

S3500428.JPG
625 hits | 52.73 KB | Posted: 3/20/04
The filter didn’t quite fit in the end of the tube, so I sanded it a bit.

S3500430.JPG
604 hits | 63.5 KB | Posted: 3/20/04
Ready for a pipe clamp and installation

S3500434.JPG
643 hits | 36.08 KB | Posted: 3/20/04
I made a bracket out of steel I bought at Lowes to hold the tube and filter, the rubber “grommet” I ...

S3500435.JPG
620 hits | 79.4 KB | Posted: 3/20/04
It fits between the tubes like this.

S3500498.JPG
637 hits | 59.09 KB | Posted: 3/20/04
The braided tube was too big to fit over the part on the fill neck so I used an old piece of the bre...

S3500443.JPG
583 hits | 80.04 KB | Posted: 3/20/04
There is the filter installed.

S3500437.JPG
624 hits | 61.98 KB | Posted: 3/20/04
I used 3” exhaust pipe to make the parts that connect the filter to the intake tubes.

S3500440.JPG
638 hits | 70.33 KB | Posted: 3/20/04
Painted them with black rustoleum to maybe prevent rust.

S3500446.JPG
669 hits | 50.52 KB | Posted: 3/20/04
Painted and installed in the filter, they almost look factory.

S3500447.JPG
643 hits | 57.25 KB | Posted: 3/20/04
Damn you rain DAMN YOU!

S3500448.JPG
656 hits | 75.51 KB | Posted: 3/20/04
With a little help from my rustolium and the bronco half in the garage I got back to work.

S3500451.JPG
619 hits | 38.71 KB | Posted: 3/20/04
The filter had a screw on the end, I'm assuming for the actual kit. I made a bracket out of aluminu...

S3500452.JPG
757 hits | 74.53 KB | Posted: 3/20/04
There it is all done.

S3500497.JPG
630 hits | 69.72 KB | Posted: 3/20/04
A better view of the breather. The reason I did it like this was because, as many of us know the PC...

S3500499.JPG
653 hits | 70.85 KB | Posted: 3/21/04
After a day of driving I realized that there needed to be some kind of bracket on the other side of ...

S3500500.JPG
635 hits | 61.51 KB | Posted: 3/21/04
It just bolts to the inner-fender.

S3500501.JPG
694 hits | 67.45 KB | Posted: 3/21/04
Now there’s lots of space, and no bouncing.