Picture 031.jpg 2722 hits | 91.53 KB | Posted: 4/2/04 Talk about clearance to spare ! Thank you WD-40 for the idea
Picture 037.jpg 2649 hits | 96.47 KB | Posted: 4/2/04 Things have changed since we necked down into this stock muffler and tailpipe. More to follow
Picture 032.jpg 2890 hits | 89.51 KB | Posted: 4/2/04 Actually picked up more room around starter for removal, etc.
Picture 073.jpg 2772 hits | 35.04 KB | Posted: 4/10/04 Plottin' and a schemin' Pretty much all you need to buy and partially weld ahead of time. Ignore the...
Picture 026.jpg 2903 hits | 52.65 KB | Posted: 4/23/04 Four 3" header flanges from J.C.W and one Mr.Gasket ultraseal 3" header gasket, less than $7 CDN a p...
Picture 078.jpg 2620 hits | 40.61 KB | Posted: 8/13/04 3" Catco with JCW 3" header flanges welded to both ends. Note it's still only 14" long with the fla...
Picture 010.jpg 2674 hits | 38.86 KB | Posted: 8/24/04 For those about to build. Here's the Flowmaster 2 into 1 Y connection pipe. Wish I'd shot the insi...
Picture 013.jpg 2438 hits | 52.8 KB | Posted: 8/24/04 Here's a shot of the overall length of the components.
Picture 012.jpg 2428 hits | 52.39 KB | Posted: 8/24/04 Originally I built this reducer to allow re-using the stock 2 1/4" muffler and tailpipe (cause I was...
Picture 018.jpg 2461 hits | 39.9 KB | Posted: 8/24/04 Want to make your pipe bender's job even easier ? These are sold at jobbers (Canadian Tire too) for...
Picture 019.jpg 2112 hits | 52.17 KB | Posted: 8/24/04 They're made so they slip right over the 2 1/4" pipe I was using for the headpipes that run into the...
flo-15925_w.jpg 1482 hits | 19.92 KB | Posted: 2/1/08 These ain't cheap, at @$70.00 a pair, but they disconnect faster than my header flanges.
IMG_0025.JPG 1495 hits | 52.62 KB | Posted: 1/2/09 What do you do, after six years of Ontario salt damage, when your collector flange falls off when th...
IMG_0021.JPG 1528 hits | 48.64 KB | Posted: 1/2/09 Not pretty on the outside anymore, but inside the flow qualities of that Flowmaster Y are unfettered...