IMG_0062.JPG
2366 hits | 60.82 KB | Posted: 5/21/04
Don't need to pull this just to change the pump, but we're going in for the timing chain gear set, s...

IMG_0063.JPG
2109 hits | 38.87 KB | Posted: 5/21/04
Here's what we're after next. Get these four 9/16" bolts out and the pulleys come off the harmonic ...

IMG_0066.JPG
2306 hits | 70.15 KB | Posted: 5/21/04
Use em' if you got em'. Usually you don't even need to block the crank as the impact will back them ...

IMG_0069.JPG
2755 hits | 79.64 KB | Posted: 5/21/04
Give it up sweetness, with a 24" bar it's already over ! The other Fram you see is the remote trans ...

IMG_0073.JPG
2277 hits | 68.8 KB | Posted: 5/21/04
Good old $3 off-shore puller ! Running Mopars for 25+ years, no balancer goes un-marked ! For heaven...

IMG_0074.JPG
2747 hits | 72.69 KB | Posted: 5/21/04
Easier than fishing with dynamite ! Check the balancer shaft snout. If it doesn't clean up or if th...

IMG_0076.JPG
2804 hits | 57.15 KB | Posted: 5/21/04
Well that's just outta focus ! What bozo took that ?! Maybe you can make out the timing marks lined ...

IMG_0081.JPG
2294 hits | 63.38 KB | Posted: 5/21/04
While you're waiting for me to run out and buy the TC set you can check out the distributor gear's r...

IMG_0082.JPG
2291 hits | 61.5 KB | Posted: 5/21/04
Who knew this stuff was dishwasher safe ? Or how to get/stay single. Guess who's outta town ?

IMG_0131.JPG
2749 hits | 50.04 KB | Posted: 5/24/04
All clean and painted. I glued the cork oil pan corner gaskets on the night before so it'd be one le...

IMG_0123.JPG
2320 hits | 38.36 KB | Posted: 5/24/04
Too much time on your hands ? Paint up your timing indicator tab so you can see them against the ma...

IMG_0137.JPG
2731 hits | 82.87 KB | Posted: 5/24/04
Torquing the cam bolt often requires jamming in a punch, shown here, to tighten against.

IMG_0140.JPG
2279 hits | 65.04 KB | Posted: 5/24/04
Don't forget to chase all the threads with a tap to clean them out. I did the TC case cover before p...

IMG_0145.JPG
2524 hits | 63.67 KB | Posted: 5/24/04
Slip in the two lowest bolts a few threads then lever the case down with the punch and draw it onto ...

IMG_0150.JPG
3269 hits | 60.52 KB | Posted: 5/24/04
Several bolts pass through the water pump first and then the TC cover, so be prepared to bolt on the...