Valkerie_VSTOL.jpg
1273 hits | 66.74 KB | Posted: 6/30/03
V/STOL Aircraft. Airbrush, marker, pencils, pastels.
VSX_Rear.jpg
1048 hits | 34.21 KB | Posted: 6/30/03
The VSX was designed around the Integra engine/chassis setup almost 4 years before the arrival of the Acura RSX! Scaled-up bodywork would fit on an Integra chassis.
11Awaiting_Paint.jpg
1047 hits | 34.21 KB | Posted: 6/30/03
After countless man-hours of sanding with progressively finer grits (approx. 50-60 hrs.), the model is ready for it's final coat of primer.
1Greenfoam.jpg
1021 hits | 34.21 KB | Posted: 6/30/03
Carving the greenfoam for the body.
8Fiberglass.jpg
956 hits | 34.21 KB | Posted: 6/30/03
The fiberglass weave in place. Not shown: Two gelcoats, second fiberglass layer.
7Heat_Guns.jpg
931 hits | 34.21 KB | Posted: 6/30/03
The wood glue drying under twin heat guns, set on low. Note distance of guns to avoid melting of the greenfoam.
9Bondo_work.jpg
931 hits | 34.21 KB | Posted: 6/30/03
Fiberglass resin and Bondo are then mixed together and applied liberally over the model. Once a thick coat is achieved, it can be sanded smooth.
10Primer.jpg
909 hits | 34.21 KB | Posted: 6/30/03
Primer is sprayed on and sanded off to determine where the low spots on the model are. Bondo can then be applied, or the trouble area sanded lower, depending on the issue.
5Sculpted_Foam_2.jpg
905 hits | 34.21 KB | Posted: 6/30/03
This was accomplished using palm sanders, filecards, sanding blocks and penknives.
Maintenance & Modification Logs
This user hasn't added any log entries, yet.
