driversside.jpg
4685 hits | 78.06 KB | Posted: 6/3/05
drivers side using the stock hanger, a 2" lowering shackle for a ford p/u and using the stock front ...

passside.jpg
2151 hits | 74.68 KB | Posted: 6/3/05
this is the drivers side stock hanger on the pass side (and vice versa for the previous pic) the hol...

finalangle.jpg
1945 hits | 52.87 KB | Posted: 6/8/05
lowered the hanger a little (about an inch) by drilling new holes. After playing around for a day, ...

castperch.jpg
1878 hits | 75.17 KB | Posted: 6/8/05
I tried finding some new "better" perches, but decided that the original cast steel ones were hard t...

tool.jpg
1786 hits | 57.76 KB | Posted: 6/8/05
had to make this tool to tighten the upper nut/bolt for the shackle

whytool.jpg
1901 hits | 72.72 KB | Posted: 6/8/05
this is why? Not a crows foot, or anything else i had would ork. im sure there is some tool out th...

pinionangle.jpg
2019 hits | 80.83 KB | Posted: 6/8/05
here is the final pinion angle. Its a tad low, but I figure once the springs break in and everythin...

shacklereinforce.jpg
2075 hits | 79.1 KB | Posted: 6/8/05
reinforced the shackle also with some 3/16 plate and some 1" angle iron. It is a 2" lowering shackl...